Skip to content
Specialized Wolf repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Wolf Wall Oven Codes E46 and E48: Pyrolysis Overheat

Error code E46 / E48
Appliance Wall Oven
Quick answer

E46 and E48 indicate high cavity temperature in pyrolysis phase 2. A 30-second breaker reset is Wolf's owner step.

Error-code meanings can vary by Wolf product type, series, and model. Confirm the code against the documentation for your exact model before using troubleshooting information. Record your full model number before acting. Code shown: E46 / E48.

Plain language

What this code means

E46 and E48 on the Wolf 24-inch E Series (SO24) wall oven are an elevated cavity temperature in phase 2 of pyrolysis operation.

Self-clean codes

The oven’s high-heat cleaning mode is called pyrolysis, and E46 and E48 are tied to it. For both, Wolf’s wording is elevated cavity temperature in phase 2 of pyrolysis operation.

At a glance

Code E46 / E48
What it means E46 and E48 on the Wolf 24-inch E Series (SO24) wall oven are an elevated cavity temperature in phase 2 of pyrolysis operation.
What you can check Do not open the door during a clean, and wait for the oven to cool completely. Then turn the breaker off for 30 seconds, turn it on, and test with ordinary baking, noting whether the code appears.
When to call a technician Book a service visit rather than running the oven repeatedly if the code returns. Say whether it came during a clean.

What the codes tell you

Phase 2 is where the problem occurs: the cavity measured hotter than the oven expected at that stage. The Wolf pages give no cause, so no part such as a door seal, a thermostat or the sensor is singled out.

Sensible steps

  • Do not open the door during a clean; the cavity is extremely hot.
  • Wait for complete cooling.
  • Turn the breaker off, wait 30 seconds, turn it on.
  • Test the oven with ordinary baking.
  • Note whether the code appears during that regular use.

Whether to start another clean right away is not addressed by Wolf. Holding off until the oven has shown it behaves in regular use is the careful approach.

Past the reset

If E46 or E48 returns, Wolf has no further advice and refers owners to its service contacts. An oven that overheats its cavity in a clean is better inspected than run repeatedly.

Other pages to look at

  • E35 / E38 concern the electronics area temperature.
  • E10 is a break in the temperature sensor circuit.

Repair for Wolf ovens, five metro areas

Phone (844) 886-0581 to reach service in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Report the E46 or E48 code, the model, and whether it came during a clean. The oven repair page gives the overview.

Source: Wolf answers: SO24 E Series E46; E48

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Seeing this code on your Wolf appliance?

Book a specialist visit for a clear estimate and approval before any repair.

Ready to get your Wolf appliance working again?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book a Repair