Skip to content
Specialized Wolf repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Wolf Wall Oven Codes E35 and E38: Electronics Overheat

Error code E35 / E38
Appliance Wall Oven
Quick answer

Both E35 and E38 mean the electronics area temperature was too high, with three possible causes and one reset.

Error-code meanings can vary by Wolf product type, series, and model. Confirm the code against the documentation for your exact model before using troubleshooting information. Record your full model number before acting. Code shown: E35 / E38.

Plain language

What this code means

E35 and E38 on the Wolf 24-inch E Series (SO24) wall oven mean the electronics area temperature is too high, with a second appliance, exhaust fan failure or a power failure during baking as possible causes.

One meaning, two numbers

Wolf publishes matching answers for E35 and E38 on the SO24 E Series wall oven. Either one reports that the electronics area got too hot, outside the range the control electronics are meant to stay in.

At a glance

Code E35 / E38
What it means The electronics area of the oven got too hot.
What you can check Let the oven rest, then cut its breaker for 30 seconds and switch it back on. Think back to whether the oven ran a long bake beside another heat-producing appliance or the power dropped mid-bake.
When to call a technician If E35 or E38 comes back, a service visit is needed, as there are no further owner steps. Say which code showed and what else was running nearby.

Causes listed

  1. A second appliance, which Wolf says may be responsible for the heat.
  2. Failure of the exhaust fan.
  3. A power failure while the oven was baking.

Which one fits?

The source has no test for any of these. Your memory of events can still narrow things: whether the oven ran a long bake beside another heat source, or whether the power dropped or lights flickered mid-bake, is useful to relay.

What to do

Allow the oven to rest. Then cut its breaker for 30 seconds and switch it back on. After a one-off overheating following an outage, the code might not return.

Stop here if it returns

When E35 or E38 comes back, Wolf lists no further steps and refers owners to its service contacts.

Compare

  • E46 / E48 relate to cavity temperature in pyrolysis phase 2.
  • E13 is another electrical code where the breaker reset is the lone owner step.

Wolf oven repair in metro areas we serve

Phone (844) 886-0581 for service in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Mention which of E35 or E38 showed, the model, and what else was running nearby; the oven repair page has an overview.

Source: Wolf answers: SO24 E Series E35; E38

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Seeing this code on your Wolf appliance?

Book a specialist visit for a clear estimate and approval before any repair.

Ready to get your Wolf appliance working again?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book a Repair