Skip to content
Specialized Wolf repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Wolf Dual Fuel Range Code 0B (E11): Calibration Error

Error code 0B / E11
Appliance Dual Fuel Range
Quick answer

Code 0B (E11) is an analog to digital calibration error on a legacy Wolf dual fuel range that may clear on its own.

Error-code meanings can vary by Wolf product type, series, and model. Confirm the code against the documentation for your exact model before using troubleshooting information. Record your full model number before acting. Code shown: 0B / E11.

Plain language

What this code means

The control reported an analog to digital error during its calibration phase.

Names for one code

The display can read OB, Ob, E11 or E 11. Wolf lists them as one legacy dual fuel range entry, 0B, and its article says that no action is required when the oven runs normally after a reset.

At a glance

Code 0B / E11
What it means An error occurred while the oven control calibrated its analog to digital conversion at startup.
What you can check Switch the breaker off for 30 seconds, turn it on and run the oven normally, watching the display over several cycles. If no errors follow, no action is required.
When to call a technician Book service if the code comes back or other errors appear, since the range then needs diagnosis and repair. Keep a dated note of each repeat for the technician.

The calibration step

As the oven control starts, it turns analog readings, for example sensor voltages, into numbers. This is the analog to digital conversion. Code 0B says an error happened while that conversion was being calibrated. No specific part is blamed.

Reset method

Turn the home circuit breaker off, wait 30 seconds, turn it on, and run the oven in the ordinary way while keeping an eye on the display for several cycles.

Deciding what to do

  • Oven works with no more errors: no action is required.
  • Code comes back, or other errors show: service is necessary to diagnose and repair.

Same label, different product

A convection steam oven from Wolf also has an E11 code, with a processor fault meaning. On this range, E11 is only another way of writing 0B.

Note repeats

Because Wolf excuses the code only when no errors follow, record each repeat with its date and the oven’s activity at the time. A list like that helps the technician.

Close relatives

Wolf range repair in the metro areas we serve

When 0B persists on a Wolf dual fuel range in Miami, New York, Houston, Los Angeles or San Diego, phone (844) 886-0581 and give the number of occurrences since your last reset.

Source: Wolf Answers: Legacy Dual Fuel Range Error Code 0B and E11

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Seeing this code on your Wolf appliance?

Book a specialist visit for a clear estimate and approval before any repair.

Ready to get your Wolf appliance working again?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book a Repair