Skip to content
Specialized Wolf repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Wolf Dual Fuel Range Code PROBE SHORTED: Probe Failure

Error code PROBE SHORTED
Appliance Dual Fuel Range
Quick answer

PROBE SHORTED on a Wolf dual fuel range: a failed meat probe. Seat the connector, reset the breaker, replace the probe.

Error-code meanings can vary by Wolf product type, series, and model. Confirm the code against the documentation for your exact model before using troubleshooting information. Record your full model number before acting. Code shown: PROBE SHORTED.

Plain language

What this code means

PROBE SHORTED reports a failed temperature probe (probe shorted) on a Wolf oven.

When PROBE SHORTED shows on a Wolf oven display, Wolf’s stated cause is a failure of the temperature probe. That probe is the meat probe that plugs into the oven wall, used for cooking to an internal temperature. It is a plug-in accessory, so this message is one of the few where a part may be the fix.

At a glance

Code PROBE SHORTED
What it means The oven reports that the meat temperature probe has failed (shorted).
What you can check Push the meat probe all the way into its wall receptacle and make sure the connector is fully seated. If that does not help, touch Off and reset the oven and probe temperatures.
When to call a technician If the code persists after fitting a new probe, the fault lies elsewhere and a service visit is needed. Stop swapping probes and give the technician the code.

Quick checks

Wolf’s entry for code 09 on the older dual fuel range (meat probe detected as shorted) says to check the probe is pushed all the way into the receptacle. Its E Series oven entry gives these actions for the same message:

  • verify the probe connector is fully seated;
  • touch Off;
  • reset the oven temperature and probe temperature.

Probe replacement

Wolf’s legacy dual fuel entry says to replace the temperature probe. It says the replacement is obtained through a parts distributor that Wolf names. The wall oven entry adds that a reset of power at the breaker may be needed once the new probe is in, to clear the code.

When a new probe does not help

The fault then lies elsewhere. Wolf tells owners to contact its service channel for a repair visit, so stop exchanging probes.

Handling tip

Take hold of the handle, never the cable, and allow the probe to cool before taking it out of the wall socket. This is general good practice, not a Wolf instruction.

Other probe-shorted entries

Code 09 and 3031 have their own Wolf listings with probe-shorted wording. The number on your display decides which one applies.

Dual fuel range probe repair: Miami, New York, Houston, Los Angeles and San Diego

For a probe error that stays after a new probe, phone (844) 886-0581. Have the oven, the probe you fitted and the code ready. The dual fuel range service page gives the background.

Source: Wolf answers, legacy dual fuel range; Wolf answers, common wall oven codes; Wolf answers, E Series oven

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Seeing this code on your Wolf appliance?

Book a specialist visit for a clear estimate and approval before any repair.

Ready to get your Wolf appliance working again?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book a Repair