Skip to content
Specialized Wolf repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Wolf Wall Oven PROBE SHORTED Code: Probe Failure

Error code PROBE SHORTED
Appliance Wall Oven
Quick answer

PROBE SHORTED flags a failed temperature probe. Seat it, reset, and replace it if needed.

Error-code meanings can vary by Wolf product type, series, and model. Confirm the code against the documentation for your exact model before using troubleshooting information. Record your full model number before acting. Code shown: PROBE SHORTED.

Plain language

What this code means

Temperature probe failure reported as a shorted probe.

Short version

Of the Wolf oven messages, this is one where an owner can do something early: the cause named is the probe, and the probe is within reach.

At a glance

Code PROBE SHORTED
What it means The temperature probe has failed and reads as shorted.
What you can check Press Touch Off, check that the probe connector is pushed all the way into the receptacle, and reset the oven temperature and the probe temperature.
When to call a technician If the message stays, the probe needs replacing. If a new probe leaves PROBE SHORTED on the display, the problem lies elsewhere and a service visit is needed.

PROBE SHORTED reports a failed temperature probe, and the temperature probe is where Wolf tells you to begin. The message is covered for L Series ovens, E Series ovens and Legacy Dual Fuel products.

How the oven gets there

  1. The probe connects at a receptacle in the oven cavity.
  2. Its signal is monitored by the control.
  3. When that signal reads shorted, the control calls it a probe failure.

The cause Wolf gives is just a probe failure.

E Series order of steps

  1. Press Touch Off on the control.
  2. Check that the connector is pushed all the way into the receptacle.
  3. Reset oven temperature and probe temperature.
  4. If the message stays, replace the probe, ordering it from a parts distributor Wolf points to.

L Series and Dual Fuel answers

Both go to a new probe immediately. After installation the oven could need a power reset at the circuit breaker before the code clears. Wolf’s answers agree on the cause; only the count of steps before the swap differs, so the seating check is a free first move.

When a new probe changes nothing

Wolf names service as the next move, since the problem then lies somewhere other than the probe.

On a range

The same PROBE SHORTED message is listed for the Legacy Dual Fuel range, and its answer follows the L Series pattern of going straight to a new probe.

See also

  • 03 x 0: probe failure shown in the older numbered format.

Wolf oven service in Miami, New York, Houston, Los Angeles and San Diego

When a replacement probe leaves PROBE SHORTED on the display, our team covers the Miami, New York, Houston, Los Angeles and San Diego metro areas. Phone (844) 886-0581, and mention the model and which probe went in. The oven service page lists what we handle.

Source: Wolf answers, Wall Oven Probe Shorted Error Code; Wolf E Series Oven Probe Shorted Error; Legacy Dual Fuel Probe Shorted Error

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Seeing this code on your Wolf appliance?

Book a specialist visit for a clear estimate and approval before any repair.

Ready to get your Wolf appliance working again?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book a Repair