03 x 0 means a probe failure on a Wolf Legacy E Series oven, and Wolf lists owner steps for it.
Error-code meanings can vary by Wolf product type, series, and model. Confirm the code against the documentation for your exact model before using troubleshooting information. Record your full model number before acting. Code shown: 03 x 0.
Plain language
What this code means
Wolf lists a temperature probe failure, displayed as PROBE SHORTED, for 03 x 0.
Most codes in the 03 range leave owners with nothing to try. 03 x 0 is an exception, since the component is the meat probe that is inserted by hand. The display shows PROBE SHORTED on Legacy E Series Wolf ovens, and Wolf’s cause line is “temperature probe failure.”
At a glance
Code
03 x 0
What it means
The temperature probe has failed, shown as PROBE SHORTED on the display.
What you can check
Touch Off, check that the probe connector is seated completely in the oven's receptacle, then reset the oven temperature and the probe temperature. Let the probe cool before unplugging it.
When to call a technician
If the message hangs on, replace the temperature probe. If a new probe still gives 03 x 0, book a service visit. Skip any bent or damaged probe.
Order of Wolf’s steps
Touch Off.
Check that the probe connector is seated completely in the oven’s receptacle.
Reset the oven temperature and the probe temperature.
Seating the connector comes first. A cause is not named.
After those steps
If the message hangs on, Wolf calls for a replacement temperature probe. It comes through a Wolf parts distributor, and the answer carries links to two Wolf articles, one about the number of probes supplied with a product and one about the probe that fits L Series, E Series and Dual Fuel wall ovens. When a new probe still gives 03 x 0, a referral to service follows, and the entry stops there.
Precautions with the probe
Allow it to cool prior to unplugging, because the metal gets hot.
Skip any probe that is bent or damaged.
Where else probe faults appear
PROBE SHORTED is the text version of this same fault.
E17 is a food probe short circuit, listed for SO24 E Series ovens.
E18 is a food probe break or loose contact, also an SO24 entry.
E Series oven repair in our metro areas
If a new probe still gives 03 x 0, call (844) 886-0581 from the Miami, New York, Houston, Los Angeles or San Diego metro areas. Tell us what was replaced and that the connector is seated. Service information sits on the Wolf oven repair page.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Wolf appliance?
Book a specialist visit for a clear estimate and approval before any repair.