Skip to content
Specialized Wolf repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Wolf Dual Fuel Range Error 03: Open RTD Sensor Circuit

Error code 03
Appliance Dual Fuel Range
Quick answer

Error 03 reports a broken RTD sensor loop on a legacy Wolf dual fuel range; cooling fans may run continuously.

Error-code meanings can vary by Wolf product type, series, and model. Confirm the code against the documentation for your exact model before using troubleshooting information. Record your full model number before acting. Code shown: 03.

Plain language

What this code means

The control detects an open circuit on the RTD oven sensor.

Key facts

  • Display: err 03
  • Cause in Wolf’s article: open circuit detected on RTD oven sensor
  • Reported symptom: cooling fans running non-stop
  • Owner action: breaker reset, then retest

Open circuit, explained

The RTD gives the control its oven temperature by changing resistance as it heats. When the circuit through it is open, the signal path is broken and the control receives nothing it can use. It therefore cannot judge the true temperature and reports an error instead. Wolf does not state whether the fault is the sensor itself or the wiring to it.

At a glance

Code 03
What it means The control detects an open circuit on the RTD oven sensor.
What you can check Cut power at the home breaker for 30 seconds, turn it back on and check that the oven operates. Do not replace any sensor or part yourself.
When to call a technician If err 03 remains after the reset, schedule a service visit. Mention that the cooling fans were running non-stop, as that belongs to this same code.

Reset sequence

Cut power at the home circuit breaker for 30 seconds. Put it back on. Check that the oven operates. This is the whole procedure Wolf publishes.

About the running fans

Wolf includes continuous cooling fan operation in the symptom list. It gives no separate reason for it, so read it as part of this same code and not as another fault.

Open versus shorted

Code 04 is the mirror case: a shorted RTD circuit. Between them, a technician learns whether to look for a break or for contact where there should be none. Avoid replacing sensors or parts yourself.

If 03 remains after the reset, Wolf directs owners to service.

See also

Legacy Wolf range service in the metro areas we cover

For legacy Wolf dual fuel ranges in Miami, New York, Houston, Los Angeles and San Diego, phone (844) 886-0581. Say that the display reads err 03, note the fan behavior, and say you already cycled the breaker.

Source: Wolf Answers: Legacy Dual Fuel Range Error Code 03

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Seeing this code on your Wolf appliance?

Book a specialist visit for a clear estimate and approval before any repair.

Ready to get your Wolf appliance working again?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book a Repair