Skip to content
Specialized Wolf repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Wolf Dual Fuel Range Error Code 6020 (RS485 Network)

Error code 6020
Appliance Dual Fuel Range
Quick answer

Wolf 6020: UIM RS485 network fault. The listed owner step is a 30-second breaker reset.

Error-code meanings can vary by Wolf product type, series, and model. Confirm the code against the documentation for your exact model before using troubleshooting information. Record your full model number before acting. Code shown: 6020.

Plain language

What this code means

The UIM reports an error on the RS485 network.

If a Wolf dual fuel range shows 6020, Wolf calls it a UIM RS485 Network Fault, caused by the UIM detecting an error with the RS485 network. The abbreviation UIM goes unexplained. RS485 is a standard wired connection that lets separate boards swap data, so the message concerns boards communicating rather than the oven failing to heat.

At a glance

Code 6020
What it means The UIM reports an error on the RS485 network.
What you can check Switch off the range's breaker at the electrical panel, count to thirty, then switch it back on. Operate the range and watch whether 6020 returns.
When to call a technician If 6020 comes back after that reset, arrange a service visit. Nothing else can be done at home, and you can mention that the breaker was already cycled.

Wolf’s listed reset

  1. Switch off the range’s breaker at the electrical panel.
  2. Count to thirty, then flip it back on.
  3. Operate the range and see if 6020 returns.

Wolf’s page offers owners nothing else.

If the code is back

Wolf says to treat it as a service matter if the reset does not resolve it, with Wolf’s own service route as the contact. Further diagnostics are not given, so at home the reset is the limit.

One reset is reasonable

Wolf lists no reason behind the reset. Still, cutting power lets the control electronics restart from the beginning, the only mechanism an owner can trigger. Keep the breaker fully off for a complete thirty seconds before restoring it. A 6020 after that calls for service.

Comparison with other network codes

Code Wolf’s name
2C21 Right or single oven PCM RS485 network fault
COMM ERR Lost communication with the oven controller
KEY COMM Controller and control panel failure

Wolf range control repair in the metro areas

For a persisting 6020, ring (844) 886-0581; we serve Miami, New York, Houston, Los Angeles and San Diego. Have the model number ready and say the breaker was already cycled. See the dual fuel range repair page too.

Source: Wolf answers, dual fuel range

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Seeing this code on your Wolf appliance?

Book a specialist visit for a clear estimate and approval before any repair.

Ready to get your Wolf appliance working again?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book a Repair