Skip to content
Specialized Wolf repair service. Experienced technicians, genuine parts, service across major U.S. metro areas.
Error Code

Wolf Warming Drawer Code 60: 250F Overheat

Error code 60
Appliance Warming Drawer
Quick answer

60 shows when the drawer climbs to 250°F. Wolf lists ambient heat, installation and a breaker reset.

Error-code meanings can vary by Wolf product type, series, and model. Confirm the code against the documentation for your exact model before using troubleshooting information. Record your full model number before acting. Code shown: 60.

Plain language

What this code means

Warming drawer temperature rises to 250°F in any mode or state.

What triggers it

When the drawer’s temperature rises to 250ºF, whatever mode or state it is in, 60 appears, per Wolf. The answer also carries “stuck relay” among its search topics.

At a glance

Code 60
What it means The drawer temperature has risen to 250 degrees F in any mode or state.
What you can check With food inside, open the drawer slowly using oven mitts and keep the unit off. Check that the room or outdoor spot is not extremely hot, confirm the installation follows the Installation Guide, then reset at the breaker for 30 seconds.
When to call a technician If 60 remains after those checks, get service. Nothing else is available to try, so say where the drawer is installed when you call.

Handle with care

That temperature is enough to burn hands on plates, containers and food. With food inside, open the drawer slowly using oven mitts, and keep the unit off.

Wolf’s checks

  • Room or outdoor heat: the surroundings should not be extremely hot. Outdoors, direct sunlight may be enough to bring on this error.
  • Installation: verify it was done properly, using the product Installation Guide as the reference.
  • Reset: breaker off for 30 seconds, then on again, then retest the drawer.

Still showing

If none of the three helps, Wolf offers nothing further and tells owners to get service. A drawer overheating for any reason other than the ambient and installation points is not explained by Wolf.

Compare with

If the display shows the word HOT, the drawer is only more than 10°F above its set point, a milder condition. A temperature that rises too slowly is code 40.

Warming drawer repair in Miami, New York, Houston, Los Angeles and San Diego

For error 60 that stays, phone (844) 886-0581; we cover the Miami, New York, Houston, Los Angeles and San Diego metro areas. Tell us where the drawer is installed. The warming drawer service page has details.

Source: Wolf answers, Warming Drawer Series Error Code 60

Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.

Seeing this code on your Wolf appliance?

Book a specialist visit for a clear estimate and approval before any repair.

Ready to get your Wolf appliance working again?

Book a repair online or call us — clear estimates, approval before any work, and a workmanship warranty on completed repairs.

Book a repair

Tell us what’s wrong — we’ll take it from there

Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.

Hours Mon–Sat: 8:00 AM – 7:00 PM
Service area Serving Miami, New York, Houston, Los Angeles and San Diego metro areas.
Response time Same-day and next-day appointments in most areas.
Call Book a Repair