The oven's current sensor saw a power relay stuck closed. Reset the breaker for 30 seconds, then retest.
Error-code meanings can vary by Wolf product type, series, and model. Confirm the code against the documentation for your exact model before using troubleshooting information. Record your full model number before acting. Code shown: RELAY STUCK.
Plain language
What this code means
A power relay was sensed as closed when it should be open, by the current sensor on the oven controller.
On Wolf’s L Series answer, RELAY STUCK stands for a shorted power relay. The oven controller’s current sensor read that relay as closed while it was supposed to be open.
At a glance
Code
RELAY STUCK
What it means
A power relay was sensed as closed when it should be open, by the current sensor on the oven controller.
What you can check
Switch the household breaker for the oven off, wait half a minute, switch it on and run the oven again. Note whether it was idle, preheating or cooking when the message appeared.
When to call a technician
If RELAY STUCK returns, schedule a service visit and keep the breaker off rather than restarting the oven again and again. A relay that may not open is a reason to stop.
Wolf’s owner steps
Flip the household breaker serving the oven to off, and wait half a minute.
Flip it to on.
Run the oven again to see whether it behaves.
Owners get nothing beyond that from Wolf.
Message repeats
Wolf says there is no further troubleshooting advice and that the next contact should be service. A relay that might not open is a good reason to keep the breaker off rather than keep restarting an oven that displays the message each time.
Where it sits among relay messages
LOWER RELAY is a lower oven shift register feedback failure, with no owner step from Wolf.
RELAY STUCK is the one that has a breaker reset.
On a dual fuel range the matching relay problem is listed as code 0E.
Useful details for a call
The message is shown as words, so the words are the code. Make a note of whether the oven sat idle, was preheating or was cooking when it appeared, and if it came up at power-on or after heating. Wolf gives these details no meaning, though they help anyone diagnosing the fault.
Wolf oven repair across Miami, New York, Houston, Los Angeles and San Diego
If the breaker reset does not hold, phone (844) 886-0581. We take Wolf oven calls in the Miami, New York, Houston, Los Angeles and San Diego metro areas; the oven repair page has the details.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Wolf appliance?
Book a specialist visit for a clear estimate and approval before any repair.